I'm looking at page 24 of the KDSP2 manual. In the "KDSP2 Primary Menu" section it says:
---------------------------------------------------------------------------- ---------------- In SSB or CW modes, the primary menu is used for the auto-notch and noise reduction functions. In RTTY, the primary menu is the Filters menu, described below. >From the primary menu, you can toggle the noise reduction adaptive filter (generally referred to as a "denoiser" and, in the SSB mode, the auto-notch filter. You can also adjust the denoiser's level from 1 (least aggressive) to 4 (most aggressive). Let's assume you were in SSB mode using filter 2. Tap the DISPLAY button to bring up the primary menu in the K2 display: S2 nr nt ---------------------------------------------------------------------------- ---------------- At this point I don't get the results shown the manual. If I'm in the menu, I toggle to between Pri and Sec. Otherwise I get the voltage and current readings. Is there something wrong with the manual? What am I doing wrong? Where is the filters menu? Help!!! 73, Steve N6VL K2 #2289 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
