Hi Dave - the only software that I found that directly supported this in the K2 was the MixW (http://www.mixw.net/) program. As I recall, it directly supported the "KY" (could have that nomenclature wrong) commands for keying.
I did use it for a while and was able to put the right code into the function buttons in the program to have it work - and - it worked quite well! Nice to not have to deal with extra cables! I also recall that after a lot of inquiries into other software possibilities, most developers didn't want to support that command set as it presented lots of issues with internal program timing and interrupting sequences within various routines (I'm sure that I've misstated that and someone in the programming arena will correct me!) Maybe there will be some further development in this area. It would be nice! 73 es gud dxing -- Don N4HH <SNIP> I've been reading about the ability of the K3 to have CW sent on the serial cable used for rig control. From memory this was possible on the K2 but most 3rd party logging/contest programs didn't support this. Is this the same as the K3, or is the set-up different this time so standard logging and contest programs will be able to utilise this ?? Hope this makes sense!! Cheers David, Vk2NU <SNIP> _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
