Ed - my understanding is that N1MM does NOT support the "KY" command set. I too use N1MM to key through the serial port but use a simple single transistor switch to do it.
The "KY" command set would allow one to key WITHOUT any additional "keying" circuit. See page 309 of the N1MM Logger manual released on 7-10-2007 - under Supported Radios - Section 50.3 Elecraft for a reference. 73 -- Don N4HH -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ed K1EP Sent: Monday, October 15, 2007 5:42 AM To: [EMAIL PROTECTED]; [email protected] Subject: Re: [Elecraft] [K3] CW via serial cable question <SNIP> > >I've been reading about the ability of the K3 to have CW sent on the >serial cable used for rig control. From memory this was possible on >the K2 but most 3rd party logging/contest programs didn't support this. <SNIP> I was using this feature over the weekend to send CW using the serial cable line. I was using N1MM logger with my K3. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
