David Ferrington, M0XDF wrote:
I have an HM10 dual I'm planning on using with my K3 - did you find any
issues with setup for a Goldline.
None at all - I guessed that the "High Gain" range would be required for a bare HC4 element, and
that seems to be correct.
I plan on using the ProSet-K2 from the front mic connector and the HM10 on a
boom in the back. I think the Proset will need bias (does it?) and the HM10
not - I haven't figured out from the op manual whether the bias is settable
on a per connection basis yet?
Yes - you can set bias and gain *range* from the main menu separately for the front and back mic
inputs. You do have to set which one is active, and you do have to set the gain level from the knob
on the front panel *I think*. It wasn't a concern of mine so I don't know if they save the value
when you switch between front and rear connector.
The ProSet-K2 does need bias and you can set that separately for front and back connector. See page
13 for the description, and see pg 49 for the menu setup.
hope this helps! - jeff wk6i
On 30/10/07 07:36, "Jeff Stai" <[EMAIL PROTECTED]> sent:
- All my stuff is set up for Yaesu but I had a spare cable for the Goldline
which I converted to the
Elecraft pinout by moving two wires. (I like using the boom mic because it
forces me to sit up
straight...) Works like a champ.
--
Jeff Stai [EMAIL PROTECTED]
Twisted Oak Winery http://www.twistedoak.com/
Winery Blog http://www.elbloggotorcido.com/
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
