Thank you, yes helps a lot - still waiting ..... hihi
On 30/10/07 08:15, "Jeff Stai" <[EMAIL PROTECTED]> sent: > > > David Ferrington, M0XDF wrote: >> I have an HM10 dual I'm planning on using with my K3 - did you find any >> issues with setup for a Goldline. > > None at all - I guessed that the "High Gain" range would be required for a > bare HC4 element, and > that seems to be correct. > >> >> I plan on using the ProSet-K2 from the front mic connector and the HM10 on a >> boom in the back. I think the Proset will need bias (does it?) and the HM10 >> not - I haven't figured out from the op manual whether the bias is settable >> on a per connection basis yet? > > Yes - you can set bias and gain *range* from the main menu separately for the > front and back mic > inputs. You do have to set which one is active, and you do have to set the > gain level from the knob > on the front panel *I think*. It wasn't a concern of mine so I don't know if > they save the value > when you switch between front and rear connector. > > The ProSet-K2 does need bias and you can set that separately for front and > back connector. See page > 13 for the description, and see pg 49 for the menu setup. > > hope this helps! - jeff wk6i > >> >> >> On 30/10/07 07:36, "Jeff Stai" <[EMAIL PROTECTED]> sent: >> >>> - All my stuff is set up for Yaesu but I had a spare cable for the Goldline >>> which I converted to the >>> Elecraft pinout by moving two wires. (I like using the boom mic because it >>> forces me to sit up >>> straight...) Works like a champ. >> > -- Sin lies only in hurting others unnecessarily. All other "sins" are invented nonsense. -Robert A. Heinlein, science-fiction author (1907-1988) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
