I just finished putting a KPA100 kit together. All the initial tests
were satisfactory until I got to the point where it is time to check the
output of the PA above 11 watts. When I set my K2 above 11 watts I get a
High Current message with no power out. I set CAL current to 3.5 amps. I
set the CAL current to 4 amps with the same issue. The K2 works with the
amp connected at power levels below 11 watts.
Where do I start looking? I have looked around T1 and components per the
manual. The component values are correct.
Thanks,
Glenn WA7SPY
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
