Hi Glen Long time no QSO. Check the rf input circuit to the KPA100. If the K2 is looking into a short or aseriously wrong impedance, it would be real unhappy. Hope to see you on the iar one of these days. 73, Bob N6WG
----- Original Message ----- From: "Glenn Maclean" <[EMAIL PROTECTED]> To: "Elecraft List" <[email protected]> Sent: Saturday, November 03, 2007 4:00 PM Subject: [Elecraft] KPA100 no output above 11 watts > I just finished putting a KPA100 kit together. All the initial tests > were satisfactory until I got to the point where it is time to check the > output of the PA above 11 watts. When I set my K2 above 11 watts I get a > High Current message with no power out. I set CAL current to 3.5 amps. I > set the CAL current to 4 amps with the same issue. The K2 works with the > amp connected at power levels below 11 watts. > > Where do I start looking? I have looked around T1 and components per the > manual. The component values are correct. > > Thanks, > Glenn WA7SPY > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
