I'll need that announcement mail, since I use a Mac to interface to my rig. I have a wintel laptop and will use that for updates, but its only on when it has to be.
On 6/11/07 23:26, "wayne burdick" <[EMAIL PROTECTED]> sent: > If you have already received your K3, you'll need to update your > firmware in order to use our 5-pole, 2.7-kHz crystal filter. Older > firmware doesn't set up the correct passband during transmit in SSB > modes, and also doesn't allow DSP bandwidth settings below 350 Hz in > receive mode. > > To obtain K3 firmware updates, you'll need our K3 Utility program, > which can be found at: > > http://www.elecraft.com/K3/k3_software.htm > > Instructions are provided in the program itself. Just click on the > "Help" tab. > > Even though we'll be announcing all future K3 firmware updates, you may > wish to select "Check Versions Every 6 Hours" in the "Firmware" panel > of the utility program. The program will then notify you automatically > if a new revision is available. > > 73, > Wayne > N6KR -- I think computer viruses should count as life. I think it says something about human nature that the only form of life we have created so far is purely destructive. We've created life in our own image. - Stephen Hawking _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
