Hi David,
I assembled the KDSP2 recently and it worked fine. However, I assume
that solder had wicked up into the J2 contacts - it was stiff to plug in
the DSP board and then impossible to pull apart. This made it awkward
to subsequently remove the front panel. So I broke up the plastic
housing of the connectors with side-cutters, carefully, so I had
thought, and pulled out the contact remnants one by one after removing
as much solder as I could with solder wick and then putting a piece of
bare, tinned bus wire heated by the soldering iron through each hole to
clean it out. After the new connectors were installed, I encountered
the trouble previously described, which is definitely self-inflicted and
not a problem concerning faulty parts being supplied to me by Elecraft.
Many thanks for your help.
73
Kevin
VK3DAP / ZL2DAP
David Wilburn wrote:
Was the board installed and in service, and functional, or is this DSP
newly built, and you are troubleshooting it?
-
David Wilburn
[EMAIL PROTECTED]
K4DGW
K2 S/N 5982
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
