Kevin,
Since you are searching for a possible break in the board traces or a
thru-plated hole, you may do better with a scan of the board rather than
the schematic. There are scans of the KDSP2 board available at Tom
Hammond's website www.n0ss.net
73,
Don W3FPR
KBG Luxford wrote:
I am trying to find a fault in my KDSP2. Do circuit diagrams of the
two boards exist with higher resolution of the logic signals? Many of
the signals in the diagrams in the manual seem to be done with a low
resolution dot matrix printer and they are awfully hard to read.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
