> 1. Two of the plastic LCD cover bolts were too long. Will > request a couple from support once I've added the PA, just in > case something else is in error.
Be sure you didn't use two of the short 2-56 screws where the longer ones go for the VFO plate. > 2. Mating the front panel/DSP to the main RF board is tricky, > helps to take a tea break and try again in 10 minutes. Sometimes screws in the 2-D connector on the left front corner of the RF board need to be temporarily removed for the FP assembly to mate easily, but a tea break probably works good too. > 3. I couldn't get the rig to recognise there was an ATU > fitted, until I powered off and back on again. Not sure if > that is a bug or how it is... It's part of the instructions. ;>) Congrats & Enjoy, Ed - W0YK _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com