>I am having a little trouble with PSK. <big snip> Did you put the K3 in Data A mode?
You should be running mic gain so that ALC barely registers, or below. Zero is Good. Set the power however you want. I included a previous summary of settings I've uesd that might help out with this. matt - WA6EGJ K3 s/n 24 == stapled-on == Data MD: Data A TX line in setting: 20% of full scale. The output is a laptop's speaker jack and the setting reflects the playback volume set on the laptop. RX line out setting: 55% of full scale. The input is the mic jack of the laptop. RX Filter: shift it to 1 KHz Fc, and 200 to 400 Hz bandwidth. Stir as needed.... K3 Line In Gain: set at 1 to 2. This range seems fine, but it won't help to go any higher than 4 or so. IMD gets worse. K3 Line Out Gain: leave this at the default 30 setting. It works fine. K3 Mic Source: Select Line In. Don't forget to put it back when you return to voice modes. PTT-Key: I ran it DTR-Off, but you could also use RTS for keying. Set up at the home QTH is as follows- K3/10 MFJ-941 tuner Long wire antenna - 130' long at 35' above ground. Two stereo cables - 3.5mm to 3.5mm, both male USB: Elecraft KUSB. Digipan 2.0 running on XP Pro, SP2. I had a power setting of between 3 and 5 Watts. With PSK31, that's enough. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
