Hello Peter!
During the lowpower wattmeter calibration we appear to have no TX output.
Test indicate no RX either.
Please direct K3 support questions to "[EMAIL PROTECTED]" rather
than the reflector.
Sounds like you may not have the filter enabled, or perhaps one of the
cables between the synth, ref osc and rf board is not completely seated.
k3support may have better suggestions.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
