IF this changed, it was VERY VERY early on. I do not remember changing this, but if I did, it was shortly after the FAQ was first posted. CW rise and fall have not been part of the firmware for months. Elecraft optimised these settings for best CW performance.
As the FAQ says. If the need presents itself, the subject will be reviewed again to put these settings back in the FW. While FAQ updates were fast and furious following the K3's announcement, updates recently have been few. I think the last update I did was to list the TX INHB pin on the ACCY connector and add the link for the Operating Tips. 73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of DOUGLAS ZWIEBEL Sent: Saturday, December 29, 2007 1:48 PM To: [email protected] Subject: [Elecraft] rise/fall time: blind-sided >From the FAQ [snip] Can the user adjust the rise and fall time on CW? If yes, what are the steps? The CW settings have been optimized at the factory and will not be adjustable. IF a need presents itself to make them adjustable it can be done in a future firmware revision. [end snip] Wow...when did this happen? The answer used to be YES. While I"m sure the rise/fall times are good (as reported by ZV and others, but questioned by EKM), I am totally surprised that something changed in the FAQ "without notification." Or did I miss it? Since I had personal (private) email exchanges about this (rise/fall for cw) and saw the adjustability as a "feature" I liked (but did suggest that the "low end" for the rise time range was too short and would be clicky), I feel rather "empty." Not so much because this "feature" was dropped, but because I don't know what else was "changed" on the FAQ. I never did save an original copy. Is there a list of "deleted features" from the early FAQs available? Thanks, de Doug KR2Q _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
