I didn't see this when I searched the reflector and archives, so I may just be the first not to get this...
I'm about to install C8 on the bottom of the RF board. The instruction reads "Before soldering, fold it down against the board, towards the back." First, my 82 pF is labeled '820.' Assume this is correct, but can someone confirm? Second, if I fold it down toward the "back," it looks like I'll the two holes between C8 and C17. Is this correct? If so, is it important that I leave enough lead length to bend it over past the holes so I don't block them? Thanks! Jay M. -- View this message in context: http://www.nabble.com/K1-4-RF-board-%28C8%29-tp14563103p14563103.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
