For those who would like to use the large VFO A knob as if it were RIT, there's a setup just for you.
Once you have your base frequency (or RUN frequency in a contest) TAP A>B to send the VFO A frequency to VFO B. Then place the K3 into SPLIT mode. Your TX frequency will not change, but now you can tune your RX frequency with the VFO A knob to tune in those stations calling who are slightly off frequency. In the CONFIG menu there's also a B>A function that you can assign to one of the programable buttons. This feature allows you to pick up your TX frequency from VFO B to match your RX frequency on VFO A. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
