Hello,
While waiting on my K3, I decided to order and put together a K1. The whole
procedure went great. The receiver worked great and the alignment went
smooth. After I installed the transmitter parts, there is no receive. First
I'm going to check for wrong parts, cold solder joint etc. Looking at the
schematic drawings, the receive signal path goes through D10, D11 and D12
which were all installed during the transmitter parts installation section.
Does anyone have any other suggestions/ideas?
Best,
DW Holtman
WB7SSN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
