Chris,
I have my K3 hooked up to a Top Ten Yaesu decoder, and it seems to work
fine. You need to connect 5 wires: the four BCD outputs and ground. Once I
figured out the pin numbering it was straightforward (Pins on the ACC jack
are numbered 1-5, 6-10, 11-15 from right to left and top to bottom, looking
at the radio from the back).
73, andy, ae6y
----- Original Message -----
From: "G3SJJ" <[EMAIL PROTECTED]>
To: "Elecraft" <[email protected]>
Sent: Tuesday, January 29, 2008 11:46 AM
Subject: [Elecraft] Band decoder and Tx Inhibit
I wondered if any has connected up a TT Band Decoder to the ACC socket yet.
I am just about to make up a suitable cable. Also theer was some discussion
somewhile back about TX Inhibit for connecting to amps. Anyone done this. I
see it needs an external +5v source.
On my FT1kMP use the band data out socket f for my TT Decoder and pick up
+12v from there, also amp relay switching. Would have been nice on the K3!
Chris G3SJJ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
