If you loaded K3 MCU revision 1.65, please load revision 1.66 instead,
which fixes a problem with ATU TUNE that was reported by a few
customers. Rev. 1.66 is now available on our web site.
In version 1.65, tapping ATU TUN would incorrectly use the power level
set in the new TUN PWR menu entry, and afterward would set the power
knob to this TUN PWR value.
The ATU TUNE power level is automatically controlled by firmware (5 W
and 10 W are used, depending on the SWR). The TUN PWR menu entry only
sets the power level for the regular TUNE switch.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
