I've been playing with the K3 remote control commands. I've enabled the
interface with a AI2; command expecting to see "FA" responses when I
change the VFO A frequency. I do see the FA responses, however they are
not "continuous". As I tune VFO A, there is a delay in the FA response
and there is not an FA response for each tuning step. For example, I
see FA00007037110; followed by FA00007037160; with no intervening steps
such as ... 37120, ... 37130, ... 37140, etc.
Also, I don't see responses to pressing the RIT or XIT buttons on the K3
front panel.
I'm using the latest level of the firmware, 1.66. (By the way, the
software download from the web site works great!)
I'm probably missing some setting? Any ideas?
Barry, WK2S
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
