Wayne's the expert here. I believe the rig sends unsolicited "AI" data (data that isn't in response to a command) about once a second if any has changed. The programmer's reference section on AI says "within one second" under the AI1 topic, I suspect that might apply to AI2 as well.
I'll try the RIT/XIT and send a separate note in a bit. 73 de Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Barry McWilliams Sent: Saturday, February 02, 2008 5:42 AM To: [email protected] Subject: [Elecraft] K3 Programming questions I've been playing with the K3 remote control commands. I've enabled the interface with a AI2; command expecting to see "FA" responses when I change the VFO A frequency. I do see the FA responses, however they are not "continuous". As I tune VFO A, there is a delay in the FA response and there is not an FA response for each tuning step. For example, I see FA00007037110; followed by FA00007037160; with no intervening steps such as ... 37120, ... 37130, ... 37140, etc. Also, I don't see responses to pressing the RIT or XIT buttons on the K3 front panel. I'm using the latest level of the firmware, 1.66. (By the way, the software download from the web site works great!) I'm probably missing some setting? Any ideas? Barry, WK2S _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
