Hi Ed Yes, both my K2s behave the same way. Here all my activity is below about 1925 kHz, so I peak my tuning somewhere areound 1850. Hope to work you on the band. 73, Bob N6WG
----- Original Message ----- From: "k6sdw" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Monday, February 04, 2008 7:48 AM Subject: [Elecraft] 160 mtr on K2 question > > Recently installed the 160 board on K2 (3349) and tuned up per the > directions.....I notice that there's a pronounced drop in noise on either > end of the band whereas the noise comes up quite a bit at the center of the > band. Is this "normal" receiver operation on 160? > > Per the tune up directions I get full output at band ends, 1800 and 2000khz > and the 75/80-mtr band works as before. > > many tnx.......73 /ed > > -- > View this message in context: http://www.nabble.com/160-mtr-on-K2-question-tp15269012p15269012.html > Sent from the Elecraft mailing list archive at Nabble.com. > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
