Perhaps Ed will clarify, but my take is that Ed's post is a different issue. I believe he is saying that while he's in RECEIVE mode with the RX ANT selected, there's leakage of the receive signal on the transmit antenna feedline into his receiver - poor isolation in the receive antenna selection.
Personally, I haven't seen this but I haven't listened specifically for it either. 73, Barry N1EU Gary W. Hvizdak wrote: > > On Fri 8 Feb 2008 at 01:07:35 EST, Ed Gilliland (W5TM) wrote .. > > I'm have poor isolation between the transmit antenna (ANT1) and my > Beverage > (RX ANT IN). I have to switch to ANT2 to get rid of the noise from the > transmit antenna. As new as I am to the K3 I may have an option set > wrong. > > -- > > Ed, > > Wayne's recent post entitled "KXV3: (1) RX ANT signal level during TX; > (2) spectra at buffered IF output" may address your question. You can > find his post in the online Reflector archives at ... > http://mailman.qth.net/pipermail/elecraft/2008-February/082024.html > > 73, > Gary KI4GGX > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > -- View this message in context: http://www.nabble.com/K3-Rx-Antenna-Isolation-tp15350020p15354381.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
