Rich, Just found your orig email.
If you want you can call me up till 9pm PST this evening at 360-320-3436. Or tomorrow but I will probably be in and out. 73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Rich Lim Sent: Saturday, February 09, 2008 1:35 PM To: Elecraft Subject: [Elecraft] K3 Error question Hi guys, I just got around to building my K3, awesome kit! Anyhow, I was wondering if someone can help me out a little bit until I can talk to customer support on Monday. While doing the initial synthesizer calibration I keep getting an error message. I get "Error VCO" and the error code is "00003". When I turn the rid on I get the "Error PL1" message. I did check jumpers and the crystal as suggested and they are correct. Any ideas? Rich KQ9L ___________________________ Think different, Macintosh. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
