Rich, when you get a resolution, please mail me it, so I can go and update the Wiki ( <http://www.zerobeat.net/mediawiki/index.php/Firmware_Error_codes#ERR_PL1.2F 2>) with the resolution.
Sorry, I don't have any suggestions other than the troubleshooting shown in the owners manual and the Wiki page. > Think different, Macintosh. Yep, have done for 23 years :) On 10/2/08 03:57, "Greg" <[EMAIL PROTECTED]> sent: > Rich, > > Just found your orig email. > > If you want you can call me up till 9pm PST this evening at 360-320-3436. > Or tomorrow but I will probably be in and out. > > 73 > Greg > AB7R > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Rich Lim > Sent: Saturday, February 09, 2008 1:35 PM > To: Elecraft > Subject: [Elecraft] K3 Error question > > > Hi guys, I just got around to building my K3, awesome > kit! > > Anyhow, I was wondering if someone can help me out a > little bit until I can talk to customer support on > Monday. > > While doing the initial synthesizer calibration I keep > getting an error message. I get "Error VCO" and the > error code is "00003". When I turn the rid on I get > the "Error PL1" message. I did check jumpers and the > crystal as suggested and they are correct. Any ideas? > > Rich > KQ9L > > ___________________________ > Think different, Macintosh. -- It is unwise to be too sure of one's own wisdom. It is healthy to be reminded that the strongest might weaken and the wisest might err. -Mohandas K. Gandhi (1869-1948) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
