Roger, Check the KRX3 menu item in CONFIG and see if you may have turned that on somehow. PL2 would be for the sub receiver. Set the menu item to NOT INSTALLED.
Transverter instructions are on page 36 of the operating manual. ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 K3#0009 On Tue Feb 12 7:37 , " RCStimson" sent: > While trying to set up my K3's low level output for use with my Elecraft > 144 MHz Transverter, I have inadvertently screwed up my K3 system. Now I am getting the "ERR PL2" message. How did I do that? > > So, I need two things: First, how do I correct this error? That is, what > are the specific steps? The manual isn't clear on this subject. > > Second, I need the specific steps I must take to correctly set up the > K3's transverter output and input ports for use with the transverter. > > Roger K8RS >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
