Hi Roger
Now I am getting the "ERR PL2" message.
I would guess, you might, in the firmware, have "turned on" the
secondary receiver, which you won't have, because they are not being
shipped yet.
*************************************************************
The following is from page 44 of the Owners Manual:
Option Module Enables
K3 options can be installed at any time, in any order.
Once an option has been installed, use the associated CONFIG menu
entry to enable it (see list below). Then turn the K3 off and turn it
back on. This allows the K3 to find and test the module.
? KAT3 ATU module: set KAT3 to BYP.
? KBPF3 general-coverage band-pass filter module: set KBPF3 to NOR (if
you?re installing a KBPF3 on the sub receiver, tap SUB while in the
menu entry).
? KXV3 RF I/O module: set KXV3 to NOR.
? KRX3 sub receiver: set KRX3 to NOR-ANTx where x is your selected
wiring for the sub receiver?s auxiliary antenna (1 = unused KAT3 ATU
antenna, 2 = AUX RF jack, 3 = AUX RF in parallel with the RX ANT IN
jack on the KXV3). For details on sub receiver antenna sources, see
pg. 22. You may also need to set up crystal filters for the sub
receiver.
? KDVR3 digital voice recorder: set KDVR3 to NOR.
? KPA3 amplifier module: set the PA MODE menu entry to PA NOR. See
menu entry listings for information on PA and PAIO test settings.
*************************************************************
I hope this helps,
vy 73 de toby
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
