I should have checked the archives. You need to be tuned to one of
the 60M channels to perform the TxG calibration on 60M. I found it
there just as the message from Gary came in with the same info.
Red faced and all.
73,
Mike WA3KYY
At 06:12 PM 2/14/2008, you wrote:
I've run into a minor glitch in the assembly of K3 #379. I made it
up to the point of doing the 5W Transmitter Gain calibration without
a problem. That went fine on every band but 60M, there I get no
more than 0.4W and a ERR TxG message when I exit Tune. The
installation of the 100W amp and the final steps are on hold until I
hear back from K3support which means using the K3 in the ARRL CW
contest this weekend is very much in doubt.
On the other hand, while waiting for a reply I snagged VP6DX on 17M
at about 22:55Z with my trusty K2 for my first QSO with them.
73,
Mike WA3KYY
K2 #2221
K3 #379
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
