Gary,
The first order of business would be to look for an unsoldered
connection. The likely places are the Control Board and the Front Panel
board. Sorry, but I cannot speculate further without additional
information. If you do not find that elusive solder connection, then
you should begin troubleshooting with the DC voltage measurements -
again, the Control Board and the Front Panel Board are the initial prime
suspects.
73,
Don W3FPR
Gary Krause wrote:
My K2 #6113 just quit working. I was listening to the 40 meter band
and all of a sudden no signal, and no audio. The display works but,
the frequency is frozen. The only other control that works is the
power level. None of the buttons work and the frequency can't be
changed. There are no error messages on power up and it powers up as
normal with "Elecraft" and then goes to the frequency.
I'm getting ready to take out the control board and have a look. Any
help would be appreciated.
I recently had a problem with SSB transmitting just stopping so, I may
be related.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
