Jack,
Believe the DMM and refrain from using the analog ohmmeter because it
apparently uses a high enough voltage for resistance measurements that
it can turn on solid state devices and may even damage them.
73,
Don W3FPR
Jack wrote:
Hi folks
Just building my K2. Got as far as the first resistance checks on the
RF board (page 38)
All values test correct but one.
The right end of R115 is meant to be >500 ohms to earth.
With an analogue meter it gives 2 ohms.
With a DMM on auto range it flashes between ranges wildly. But on
manual range it gives 10.2 Kohms.
Anyone shed any light on this?
Thanks
Jack
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
