Jack,
The cause of the low AGC Threshold is a low output from the 8 volt
regulator (Control Board U4)
It will llikely not cause any problem at all if you simply set the
Threshold to max. You could consider replacing the regulator if it
causes you concern.
73,
Don W3FPR
Jack wrote:
Setting the AGC threshold on my K2.
Adjusting R1 for 3.8 volts. But turned full up I can only achieve
3.666 volts.
Is this a problem?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
