8v regulator output was 7.96v.
Thanks for the input guys. I'll finish the rig then set again.
cheers
Jack VK2CJC / MM0AXL
FISTS #9666 - CW QRP Club #753 - Elecraft K2 #6404
Mid North Coast Amateur Radio Group www.mncarg.org
For MSN Messenger, use this emails return address
----- Original Message -----
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "Jack" <[EMAIL PROTECTED]>
Cc: <[email protected]>
Sent: Thursday, February 28, 2008 3:16 AM
Subject: Re: [Elecraft] K2 AGC set
Jack,
The cause of the low AGC Threshold is a low output from the 8 volt
regulator (Control Board U4)
It will llikely not cause any problem at all if you simply set the
Threshold to max. You could consider replacing the regulator if it
causes you concern.
73,
Don W3FPR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
