Running 100W output on 20m, using the in-built two tone test oscillator,
I measure the third order products at -30 dB relative to peak (ARRL
method of measurement) and 5th order at -40 dB.
There was a suggestion the internal two tone test oscillator gives
better results by some 3dB than can be obtained by feeding an external
two tone into the K3... That would put the above figures at about the
same as the ARRL measurements.
73 Dave, G4AON
K3/100 #80
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
