Bear with me, this is strange.... K2 / 06254 built last Fall
A few days ago I fixed a problem on my K2 (low output on 15/12/10).
Yesterday I finished a complete alignment and today reinstalled the KPA100.
So... its lashed to a dummy load and I'm stepping through the bands to make
sure the KPA100 is happy. I get to 12M and the VFO happens to be set to
25000.00, I tap the key. No output and I get an "END" message on the
display.
Move the VFO to inside the band, no more "END" message but still no output.
Change the power level - now there is normal output!
In fact, if I recreate the setup (freq to 25000.00 or higher, tap the key,
get "END"), then change to any other band - there is no output until I
change the power setting.
I couldn't find this mentioned in any of the archives. Is the firmware
getting confused or do I have a unique gremlin? The only reference to the
"END" msg I can find in the book is CAL PLL.
It's working 100% otherwise. Would appreciate it if somebody else would
give this a try!
THX & 73, Bill N2BC
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
