Bill,
The "END" message indicates that you have reached the END of the band.
The K2 is limited so it cannot be used to transmit in the CB band
(clearly not legal), so you will encounter just what you saw if you try it.
As a sidenote, questions are often asked about the END message with the
KX1 - because of the general coverage aspects of the KX1, it is easy to
tune out of the ham band, so users encounter that message frequently -
often when they have listened to WWV at 10 MHz and then try to transmit.
73,
Don W3FPR
Bill Coleman N2BC wrote:
Bear with me, this is strange.... K2 / 06254 built last Fall
A few days ago I fixed a problem on my K2 (low output on 15/12/10).
Yesterday I finished a complete alignment and today reinstalled the
KPA100.
So... its lashed to a dummy load and I'm stepping through the bands
to make sure the KPA100 is happy. I get to 12M and the VFO happens to
be set to 25000.00, I tap the key. No output and I get an "END"
message on the display.
Move the VFO to inside the band, no more "END" message but still no
output. Change the power level - now there is normal output!
In fact, if I recreate the setup (freq to 25000.00 or higher, tap the
key, get "END"), then change to any other band - there is no output
until I change the power setting.
I couldn't find this mentioned in any of the archives. Is the
firmware getting confused or do I have a unique gremlin? The only
reference to the "END" msg I can find in the book is CAL PLL.
It's working 100% otherwise. Would appreciate it if somebody else
would give this a try!
THX & 73, Bill N2BC
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
