Hi Stan, if i did not missunderstand you, the KPA3 is not working. If that is the fact i would first of all check for the settings. A common issue with the config menu is to select "io nor" instead of "nor" to enable the kpa. As a result you will not get beyond 12W...
73 Thomas, DM7TN K3/100 #78 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of DOUGLAS ZWIEBEL Sent: Wednesday, March 19, 2008 11:24 AM To: Elecraft Reflector Subject: [Elecraft] K3: can't calibrate at 50 watts I am posting this for Stan (shown below) who is not yet subscribed to the list. de Doug KR2Q Hi All, I installed KPA3, turned it ON in CONFIG, but no way to Calibrate 50W Wattmeter. Still stays in WMTR LP. Sticking pins are cut off on KPAI03 Board. Out of K-3 only Low Power. KPA3 doesn't work. Any advice, please. 73! Stan, K6WG k6wg at yahoo dot com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
