Yes, I meant fitted correctly to the FP, sounds like you have it
seated correctly.
--
Life is an eternal challenge, a variant on Maeterlinck's theme that
the Bluebird of happiness is by the side of each and everyone of us,
always within reach, yet, if pursued to catch and possess is beyond
our grasp. - Donald Campbell, CBE. (1921-1967)
On 26 Mar 2008, at 20:38, G4ILO wrote:
M0XDF wrote:
sounds like that's not fitted correctly - the flange on the connector
should be a very snug fit in the front panel hole.
Mine was so tight, I had to remove some of the paint from the rim of
the hole at the back
I don't recall there was much scope for fitting it incorrectly. It was
already installed on the PCB, and the front panel just slips over
the top.
Like you I removed paint from the inside of the hole so the front
panel
would fit on easily. If it is relying on being a tight fit in that
hole to
get its rigidity then I probably removed a bit too much.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
