Anybody know just what the voltage range can be put out at the line out jack?
Since it is pre-AGC it isn't a "constant level" output but instead varies with signal strength. CONFIG LIN OUT apparently adjusts the level. I want to directly drive a TNC which has an unbalanced 10K ohm input impedance which" can be directly connected to a wide variety of receiver audio output terminals including ... line 600ohms..... The maximum input should not exceed +1.7 V rms.." I suspect the K3's level may be too low at any setting since it is meant for sound card input. My guess is that the TNC would be happy with 0.5 volts. There doesn't appear to be any "constant" level AF output which some rigs had to drive TNC's. K3KO -- View this message in context: http://www.nabble.com/K3-CONFIG-LIN-OUT-tp16467958p16467958.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com