After repeating the power calibration on my K2 KPA100 due to low output power, I found the CAL tPA function had reset to 0C and can no longer be adjusted.
Having pressed EDIT from the CAL tPA display, the display shows tPA 0C, but turning the VFO knob has no effect on the display, it remains resolutely at 0C. Scanning the archives dug up a couple of similar issues, but no solution. Has anyone seen this? Is the there a fix? Is my brain disconnected & I'm doing something stupid (most likely scenario, I'll admit)? I'm now concerned that having fixed the output power, the fan won't switch on when it's needed. Any help appreciated. 73 Ian G4FSU _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
