N2TK wrote:
For FSK, the manual states that pin #1 (FSK IN) in ACC jack has a pull-up
resistor to 5V. So I assume the standard NPN interface from a COM port will
work fine for that.
Standard COM ports are *not* open collector. They have to actively
drive in both directions. Any input to which you connect them needs to
tolerate up to 12 volts open circuit voltage, in either polarity, with a
300 ohm source impedance. This may well require protection diodes to
prevent the substrate diode on the receiver being forward biassed. It
might also require clamping the positive excursions to less than 5 volts.
I'd suggest the simplest approach is to use a resistor and an
opto-isolator, with a reverse diode across the isolator input, to avoid
reverse breakdown of the LED.
--
David Woolley
"The Elecraft list is a forum for the discussion of topics related to
Elecraft products and more general topics related ham radio"
List Guidelines <http://www.elecraft.com/elecraft_list_guidelines.htm>
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
