thanks Vic, I suspected that was the case. Now on to the other problem.
Todd
----- Original Message -----
From: "Vic K2VCO" <[EMAIL PROTECTED]>
To: "Todd J Gahagan" <[EMAIL PROTECTED]>
Cc: "Elecraft List" <Elecraft@mailman.qth.net>
Sent: Tuesday, April 15, 2008 8:54 PM
Subject: Re: [Elecraft] Problems with K3 Calibration
Todd J Gahagan wrote:
1. In trying to do the reference oscillator calibration(I have the
1ppm TCXO) (using method 3) I can get into the CONFIG:REF CAL menu
entry, but when I tap "1" I can't get to REF xxC. Tapping 1 seems to
change the mode from CW to AM, the AGC speed, turns on the VOX, and
changes the filter from 1 to 2 but I am not able to get to REF xxC.
I'll answer the easy one: this method isn't implemented in the firmware
yet. Just use the method that zero-beats WWV.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
