K3 newbie here. Tried to test using your sequence, but stopped at the
SAV ALT1 command. My (USA Version) K3 does not have such button(s)
or entries in MAIN or CONFIG, and the Operators manual does not even
have an entry for that/those commands. Help.
Jerry W4UK
At 01:30 PM 4/28/2008, you wrote:
Hi All,
I have been experiencing a strange problem on my K3 where the
receiver is sometimes 'dead' after transmit. This seems to be tied
in with the MCU control of the DSP.
To prove that this is either unique or not to my unit, I would be
grateful if fellow K3 owners could try this quick test.
In particular I would like to hear from Beta Testers as to whether
they can replicate this problem with the next (unreleased)
firmware.
POWER
80m LSB 3780
NOR
LO CUT=0.15
SAV ALT1
NOR
TX ON/OFF
ALT1
TX ON/OFF
Receive may be dead at this point
If not continue with
Select USB
ALT1
TX ON/OFF
Receive dead
Switching bands, modes or NOR always restores receiver.
Many thanks in advance.
73
Stewart G3RXQ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
