Wire the dc cable direct into the rig and let the other end do the
disconnect. Less dc loss and no contacts to worry about.
David
G3UNA
I know the powers that be don't like complaints about the APP, but, the
Factory mounted APP's on my K3 had one of the blades recessed at least 1/8
inch from its proper position. Until I corrected this (which requires
removing that side of the cabinet and the rear panel) my connectors would
literally fall off from the weight of the short piece of power lead. It
took
more than three attempts to get both of the chassis mounted blades in the
proper position. UN-SAT. They now stay together, but I would never put
them in a rig I designed and am presently considering some type of
replacement.
Rich,
KE0X
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
