Stan, W5EWA wrote: I think one possible fix would be to use .050" shorter standoffs between the DSP board and the FP board. That would cause the shoulder of the headphone jack to be close enough to the FP sheet metal to keep the washer from rattling, and would also allow the connectors on the FP assembly to not seat quite as far down on to the mating pins of the connectors on the RF board, therefore allowing the screws for the front panel mounting to line up easier.
------------------- That also moves the front panel board closer to the front panel sheet metal where the screws holding the LCD cover can hit the LCD itself and break the glass. Ron AC7AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
