I have been carefully reading the instructions on the configuration and use of the KAT3 and I am a little puzzled by what I have found.
I was surprised to find that the KAT3 does not track the VFO on receive. I wonder if there is a reason for this? Has there been any thought on perhaps an upgrade of the KAT3 in the future? I have mono band antennas but the band edges are sometimes a little higher than say the band centre and CW portions. Tracking on receive is something I have become used to with previous radios. Still learning how this radio works, all reports so far have been exceptionally good. i just had a QSO with a station who asked me if I would like to swap it for his SteppIR beam and an FT1000...been there, done that, the K3 stays. Cheers all, Gary #679 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
