Your 2.7 / 2.8 filter is not setup for the transmit mode. I found the
filter setup in the K3 firmware updater application much easier to use
than the config menus. Take a look at your filter settings with that,
and the issue will likely be obvious.
You must have the 2.7 or 2.8 filter (which ever you have) set as your
transmit filter for each of the modes.
Dave Wilburn
K4DGW
K2/100 - S/N 5982
K3/100 - S/N 766
"For those who fought for it, freedom has a flavor the protected will
never know."
charles wrote:
ERR TXF error message received when attempting low power calibration.
No power out on CW or SSB.
I have studied the trouble shooting pages in the Owner's manual but cannot
find the answer.
Any suggestions please?
Charles - M0BIN
Sorry I should have stated that firmware revisions are:
MCU 1.88 DSP 1.70
Using Elecraft Utility version 1.1.4.1
Charles - M0BIN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
