I have K3/100 #757 using firmware 1.88 MCU and 1.70 DSP. When trying the Low-Power (5W) Transmitter Gain Calibration, it works on 80 and 20 meters, but on all other bands I get an "ERR TXG" message.
The Synthesizer Calibration and Reference Oscillator Calibration (using WWV zero beat) run OK. I have checked that I have my two filters (500 and 2.7) setup properly. I have been thru the filter bandwidth, freq center, receive filter enables, and transmit filter selections several times. Any ideas what the problem might be? 73, Paul K5ESW _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
