I would next open up the K3 update tool, and under the Configuration
tab, select the click on the Edit Crystal Filters... button. In what
ever mode you were getting the TX error on, ensure that one of buttons
on the bottom 4 (including FM if applicable) lines is selected for
that mode. As an example, in my case, the 2.70 filter is selected for
Tx CW, Tx SSB, and Tx AM.
Dave Wilburn
K4DGW
K2/100 - S/N 5982
K3/100 - S/N 766
"For those who fought for it, freedom has a flavor the protected will
never know."
Joe Word wrote:
Dave, PA is set to nor and have turned off/on multiple times.
Just checked the Circuit Breaker, it's making contact.
Joe
Dave wrote..
Have you initialized the PA in the menu and turned the rig off and on
a couple of times?
Dave Wilburn
-----------------------------------------------------------------------------------------
---------- Forwarded message ----------
From: Joe Word <[EMAIL PROTECTED]>
Date: May 13, 2008 11:28 AM
Subject: K3: High-Power TX Gain Calibration - No Output
To: [email protected]
I am having problems with the 50 watt TX Gain Calibration, it shows 0
watts and gives the error "ERR TXG". The Low-Power 5 watt test
worked fine and have low power output.
Anyone had and resolved this problem?
Running FW 1.88
Thanks,
Joe N9VX
K3 #841
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
