I fixed the problem. Removed KPA3 and found a gray wire out of T1, at the C1 end, was under the mounting bracket (KPA3 to RF Shield). The K3 now puts out full power and the High Power Gain Calibration is complete for all bands.
Thanks Gary at Elecraft for the excellent help. And thanks to all of you for your comments and suggestions. What a nice receiver!!! 73, Joe N9VX ---------- Forwarded message ---------- From: Joe Word <[EMAIL PROTECTED]> Date: May 13, 2008 11:28 AM Subject: K3: High-Power TX Gain Calibration - No Output To: [email protected] I am having problems with the 50 watt TX Gain Calibration, it shows 0 watts and gives the error "ERR TXG". The Low-Power 5 watt test worked fine and have low power output. Anyone had and resolved this problem? Running FW 1.88 Thanks, Joe N9VX K3 #841 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
