Hey Folks,
I've just finished assembling a KIO2 for my K2 (SN 3490, Firmware
2.04). It seems to be working, but it only works reliably when I set
my terminal software to use 1 stop bit instead of 2. If I set my
terminal to 2 stop bits, I get garbled data about 70% of the time.
For example, the ID; command will return ID017, ID0, ID, ID01, etc.
I've observed this behavior on both a Mac and a PC, so I don't think
it's my terminal program. I tried the MacK2 program and it works
extremely erratically, presumably because it assumes 2 stop bits. The
KIO2 manual says to use 2 stop bits, but that 1 stop bit will also work.
Before I dive into this, I thought I'd see if anyone else has
experienced this problem.
Thanks in advance for any advice.
73
Joe KB8AP
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
